Product Installation Instructions: 1. The first step, when you use the adapter card, the computer needs to be turned off before they can plug the adapter card. 2. The Second step, first of PCIe USB card plugged into the motherboard’s PCIe slot. Use USB3.0 data cable adapter to connect the ends of the two USB port. Plug in the power supply. 3. The third step: After completion of the above two steps, first in no hurry to insert your PCI-E card, start the computer to see if your computer has been identified to the riser card, if you did not find the card, repeat the above operation (Note: The first time to insert card to start the computer, into the system in general will be prompted to install new hardware, such as “PCI standard PCI-to-PCI bridge” , you need to wait for it to automatically install the complete, individual anti-virus software will prevent these files installation, note skipped), when your computer has been recognized the card,blue LED PCI slot on normal light, computer equipment manager in the system device will show an increase of several “PCI standard PCI-to-PCI bridge.After completing the above three steps, turn off the computer, plug in your PCI-E card, to be careful not to insert the contrary, Then boot into the system, install PCI-E Card Driver.1 x 4-port USB3.0 Riser Card for Mining
Only logged in customers who have purchased this product may leave a review.
Once you have some errors lower clocks a bit until there are no new errors. These clocks should be stable
After you find the best memory clocks you can set core clocks (overclock or underclock) then you can try lowering voltages.http://www.pcworld.com/article/250644/how_to_overclock_your_graphics_card.htmlHWinfo - find your GPU and the GPU memory errors line. Watch it for numbers. If there are any after few minutes your memory clock is too high. If you have few errors after hours it's no problem. But key is to have 0 errors. Memory errors can cause bad shares and may end up with BSOD
Some recommended clocks and voltages for RX cards - each card is different this is only for approx values!
Go to Lost License and insert your e-mail, system will then send your license.
All of these bios have undervolted core and memory (VDDCI), but only a bit for stability with all cards, most of them also have memory OC. All bios use performance timings or Pro performance timings. You can find most of the performance timings in my Bitcointalk guide, those Pro performance timings have higher hashrate and they are not listed in my guide. You can get them only if you have my Premium pack, Pro peformance timings bios or in PBE 2.0.